Description

These flashers are for any front and rear doors of any car, SUV, truck, recreational vehicle, and older or newer cars where safety comes first. They flash brightly, especially at night, in the event of an emergency, a breakdown, or when transferring drivers and need to pull over to the side of the road. The door electric light cables can easily be linked to the flashing multicolor lights. The rear of the LED light sticky attachment is simple to install from top to bottom; simply wipe clean and carefully position these sticky inserts.

 

【Automatic light】: open door light is on→flow light is on→red and white light is on at the same time→red light is flashing→white light is always on→closed-door light is off. Please note that the package is 1 set/2 piece of car warning lights, for better effect, please order 2 sets/4 pieces.

【Safety Warning】：While the car door is open, the red light will continue to flash to warn pedestrians, motorcyclists, bicyclists, and other drivers to avoid accidents or crashes.

 

Product Specifications.

 

Door caution light bar is the name of the product.

 

Red and white are light colors.

 

Soft silicone is the material used.

 

144 LED chips (72 red and 72 white).

 

12V voltage

 

Size: 120*1.2*0.4cm (47.24*0.47*0.16 inch)

 

Car door edge (application)

 

Accessories are universal and can be used on any vehicle.

 

2 door warning light bars + 1 door warning light bar are included in the package.

 

 Instructions for installation.

 

Please note that the doors have door lights!!!

 

1. Remove the rear sticker and adhere the light bar to the door’s edge.

 

2. Unplug the connector after prying open the door light cover.

 

3. To conceal the wire, pull it to the position of the door light.

 

4. Connect the red and black wires, positive (+) and negative (-). (-).

 

5. Finish by installing the light cover.

 

Please keep in mind that

 

1. It is not possible to cut the light bar into parts.

 

2. Before gluing the lamp, make sure the surface is clean.

 

3. Before installing the tape, heat it with a hairdryer for a stronger bonding effect.
4. Install steps:
5. 

• 
• 
• 
• 
•